A registered business in the state of Colorado (ID# 20091276671 / 20131415285)
HBA Cause 4 K9s is a registered non-profit in the state of Colorado (ID# 20131451644)
Suomi M31 Reweld Jig
Quantity in Basket:
Shipping Weight: 1.00 pounds
We are currently sold out of 'Suomi M31 Reweld Jig'.
We will be scheduling a production run as soon as possible for this item.
Please check the updates on the main store page for upcoming production run schedules.
Thank you for your patience and interest in our products.
This jig comes in 2 major halves, both are made from T6160 aluminum - the rear half being a tube style with walls nearly a full quarter inch thick. This makes it very strong and able to release absorbed heat into the air space within itself.
The forward section is solid T6160 Aluminum and is drilled through to allow a piece of all thread to pass though it. The forward piece is shouldered and sized to fit the front nose section and replicates the size of the barrel as it sits in the nose (as if it were uncut). It then continues to the rear passing through the extraction and ejection area (the forward section does have a slot that slides over the ejector) and then it ends where the forward edge of the rear half butts against the forward wall in the bolt galley.|
The jig allows the builder to align the pieces (I recommend using the FCG, rear sight base and the barrel shroud to assist in this and may require the builder to devise his own methods for jigging the pieces (since no 2 kits are cut exactly the same) but in large the jig should be usable on the majority of the cut styles I have seen.
This jig is ONLY for rewelding Original diameter tubes and is not provided with any blocking rail/pin cut outs (this is done because of the vast locations and ways that this particular tube can be blocked that we can not possibly predict where any one user would want their block to be located). This jig can be used to make a non NFA style tube as long as a block bypass Channel is created and the block installed into the receiver piece(s) BEFORE the overall rewelding process starts.
Using this jig, as designed, to reweld your pieces you will be left with a Original ID receiver
More info available here: http://www.weaponsguild.com/forum/index.php?topic=8052.0
As these are built to order, we ask that you allow 3 to 6 business weeks from receipt of payment for shipping to occur.
All ATF/NFA rules apply to purchases made from this site.
The information/products in these web pages are not intended to be used to construct illegal firearms.
It is the sole responsibility of the purchaser to know and understand all applicable Federal, State and local laws before placing an order.
By placing any order you are agreeing that you accept all legal responsibility for the products purchased and their subsequent use.
For legal semi auto and dummy gun information, contact BATF at: www.atf.gov
Every reasonable effort has been made to ensure that all photographs, descriptions and specifications on this website are accurate.
However, inadvertent errors may occur, and changes in design or materials, due to our continual effort to improve products, may result in some change in specifications before subsequent publications are issued.
HBA reserves the right to modify or change specifications with or without notice at any given time.
Any and all past or present images/text on this site are the sole property of HellBox Armory/HBA - Cause 4 K9s
No off site usage is authorized without my direct consent, violators will be asked to cease and desist (Via court filed order) in such practices, If that order is ignored then violators will be prosecuted to the fullest extent possible. I'm generally an easy guy to get along with but when others try to steal my hard work and livelihood so they can make an easy road for themselves then that is where I draw the line........
You have been forewarned!